The 1st F-Interop 6TiSCH Interoperability Event
This project was used to build firmwares for the 1st F-Interop 6TiSCH Interoperability Event, which worked well in all the tests except for “secjoin”.
The following hardwares were used in the event:
Zolertia Remote (TARGET=
CC2650 LaunchPad (TARGET=
Access to your target board through serial connection. You’ll get available
commands by hit
help on the shell prompt.
> help Available commands: '> help': Shows this help '> ip-addr': Shows all IPv6 addresses '> ip-nbr': Shows all IPv6 neighbors '> log module level': Sets log level (0--4) for a given module (or "all"). For module "mac", level 4 also enables per-slot logg'> ping addr': Pings the IPv6 address 'addr' '> rpl-set-root 0/1 [prefix]': Sets node as root (on) or not (off). A /64 prefix can be optionally specified. '> rpl-status': Shows a summary of the current RPL state '> rpl-global-repair': Triggers a RPL global repair '> rpl-local-repair': Triggers a RPL local repair '> routes': Shows the route entries '> tsch-schedule': Shows the current TSCH schedule '> tsch-status': Shows a summary of the current TSCH state '> reboot': Reboot the board by watchdog_reboot() '> 6top help': Shows 6top command usage
Your board runs as a 6TiSCH node by default. Its role can be changed to DAG root
You can see how it works with
project-conf.h if necessary.
UIP_CONF_IPV6_CHECKS: set 0 if you want to disable checksum validation
SIXP_CONF_WITH_PAYLOAD_TERMINATION_IE: set 1 if you want to append Paload Termination IE in 6P frames